pH和发酵时间对厨余垃圾发酵产乳酸及光学特性的影响

通过间歇实验探讨了在中温、非灭菌条件下,pH和发酵时间对厨余垃圾发酵产乳酸及其光学特性的影响.结果表明,采用非灭菌的厨余垃圾发酵产乳酸,发酵液中还原糖浓度低,pH调节到近中性和偏碱性（pH为6～8）的各组还原糖浓度高于偏酸性组（pH=5和pH=4的对照组）;在控制pH为7时,总乳酸产生速率达到0.59 g·(L·h)^-1,单位挥发性固体的乳酸产量达到0.62 g·g^-1;控制pH为7和8时,以有机碳表示的乳酸分别占发酵液总有机碳的78%和89%;控制pH为8时,L-乳酸是主要的异构体形式,单位挥发性固体L-乳酸产量达到0.48 g·g^-1;响应面分析结果表明,发酵时间在120 h前,随着pH升高和发酵时间的延长,发酵液中L-乳酸浓度增大,120 h后则下降;pH和发酵时间对L-乳酸占总乳酸的比例有明显影响：偏酸性条件(未调pH及pH=5),发酵前120 h,该比例随发酵时间逐渐增大,L-乳酸在总乳酸中的比例达到0.9,其后,则逐渐下降;偏碱性条件下(pH=8),L-乳酸在总乳酸中的比例在整个发酵时间段内都保持在0.86以上,在发酵时间48 h时达到0.93,而在pH中性条件下,该比例在发酵后期显著下降;控制pH为8时,可以同时获得高的乳酸产量和光学纯度.     

Residual dynamics of thiacloprid in medical herbs marjoram, thyme, and camomile and in soil

Thiacloprid is a new insecticide of the chloronicotinyl family. To assess its risk after application, residual characteristics of thiacloprid in marjoram, thyme, and camomile and in soil were studied under field conditions. The active ingredient was extracted from the plant material using a mixture of acetone-water. After filtration, the extract was concentrated to the aqueous phase, diluted with water, and portioned against ethyl acetate on a matrix solid phase dispersion column. Thiacloprid was extracted from soil using a mixture of methanol-water, filtered, and re.extracted （clean up） with dichloromethane. The residues were quantified using HPLC-MS-MS. The methods were validated by recovery experiments. Thiacloprid residues in marjoram, thyme, and camomile and in soil persisted beyond 10, 14, 14, and 21 d but no residues were detected after 14, 21, 21, and 28 d, respectively. The data obtained in this study indicated that the biexponential model is more suitable than the first-order function to describe the decline of thiacloprid in fresh marjoram, fresh thyme, and dried camomile flowers with half-life （t1/2） of 1.1, 0.7, and 1.2 d, respectively. However, both the first-order function and biexponential model were found to be applicable for dissipation of thiacloprid in soil with almost the same t1/2 values of 3.5 and 3.6 d. The results indicated that thiacloprid dissipates rapidly and does not accumulate in the tested herbs and in soil.     

微波消解-火焰原子吸收分光光度法测定固体废物中的钡

采用微波消解法对固体废物浸出液样品进行前处理,采用乙炔-空气火焰原子吸收法测定钡的含量,检出限为2．04mg／L,加标回收率为94．5％,精密度为4．85％-6．81％。     

中国危险废物和医疗废物焚烧处置行业二（口恶）排放水平研究

通过调研全国危险废物和医疗废物焚烧处置设施,对包含二噁英排放水平的设施按处置对象、炉型和处理量分类,并作系统分析和研究.结果表明现有危险废物焚烧设施烟气中二噁英的浓度比医疗废物低,达标率为74.19%;危险废物选用回转窑处置效果较好,达标率为66.67%;而医疗废物选用回转窑或热解炉,要综合考虑处置规模、生产成本和二英排放总量等因素;危险废物介于10~30 t·d-1和医疗废物介于10~20 t·d-1的处置设施要尤其注意二噁英的排放问题;医疗废物焚烧飞灰中二噁英的均值浓度为危险废物6倍以上,仅有16.67%满足填埋要求.二者烟气中二英的浓度分布以1,2,3,4,6,7,8-HpCDF、2,3,7,8-TCDF和OCDD为主.     

衡水市医疗废物处理现状调查及对策

医疗废物是一类成分复杂并有特殊危害的危险废弃物。通过分析衡水市医疗废物处理过程中存在的分散处置、处理率低等问题,提出了加强管理监督机制、提高医疗废物收集处理率的应对策略。通过综合比较分析几种医疗废物处理方法的优缺点,指出高温焚烧法集中处置是衡水市医疗废物的最佳处理方法。     

Integrated model of simulated occupant injury risk and real medical costs

Introduction

The purpose of this study was to develop an integrated methodology that links occupant injury risk functions, estimated in the laboratory, with real world medical treatment costs by using the abbreviated injury score (AIS). Using our model, the expected medical treatment costs for crash injuries to various body regions and of different severities can be investigated.

Methods

First, the simulation results are compared with NHTSA crash data. We used a modified kinematics simulation model that incorporates an F = E^b function as a supplement to the previous Steffan's model to obtain a more accurate acceleration history a(t). Second, head injury criteria HIC₃₆ can be calculated from a(t), and we use the injury probability P as a function of HIC_36, as proposed by Kuppa, to obtain the injury risk function for various AIS values. Third, medical treatment cost models for various AIS values can be calculated by using a regression cost model with real world data. Finally, the injury risk function and medical treatment cost models are linked through AIS values. We establish an integrated methodology and predict medical costs and car safety data using real world police reports, medical treatment costs, and laboratory simulation results.

Results

Using head injuries in frontal crashes as an example, we focus on simulation parameters for different vehicle models, with and without airbags. We specifically examine impact closing speed, Delta-V, and impact directions.

Conclusion

Simulation results can be used to supplement insufficient real crash data, in particular ΔV, and injury risk results from police crash reports.

Impact on industry

The proposed integrated methodology may provide the vehicle industry with a new safety assessment method. Real crash data coupling provides consumers with more realistic and applicable information.     

上海郊区小型沼气发展的前景与方向

文章介绍了上海郊区沼气开发利用的发展历程和现状，分析了上海沼气发展萎缩的原因，指出上海在节能减排的大形势、寻找合理的农村生活垃圾处理出路和解决小型禽畜养殖场的环境问题等压力下，对郊区的沼气发展产生了新的需求。而以小型养殖场为中心、吸纳农村有机生活垃圾的小型沼气系统则是上海郊区未来沼气发展的方向，也是新农村环境整治的可行途径。     

Reverse logistics in the Brazilian construction industry

In Brazil most Construction and Demolition Waste (C&D waste) is not recycled. This situation is expected to change significantly, since new federal regulations oblige municipalities to create and implement sustainable C&D waste management plans which assign an important role to recycling activities. The recycling organizational network and its flows and components are fundamental to C&D waste recycling feasibility. Organizational networks, flows and components involve reverse logistics. The aim of this work is to introduce the concepts of reverse logistics and reverse distribution channel networks and to study the Brazilian C&D waste case.     

Effect of inoculation methods on the composting efficiency of municipal solid wastes

Four types of inoculation methods were studied during the composting of municipal solid wastes and dry grass (MSWG). The methods included a control group as well as initial-stage, two-stage, and multi-stage inoculations. Fulvic acids were extracted from the composting materials and characterized by spectroscopic techniques. The results showed that inoculation of microbes in MSWG enhanced the biodegradation of aliphatics, proteins, and polysaccharides. The inoculation also increased the molecular weight, humic- and fulvic-like compound content, as well as humification degree of the composting products. The inoculation of microbes in MSWG significantly improved composting process and efficiency. The improvement efficiency was in the order of initial-stage < two-stage < multi-stage inoculations. Inoculation of microbes based on composting organic matter composition and temperature enhanced composting efficiency.     

医疗废物焚烧处理核心技术的开发及应用

国内已建成的医疗废物焚烧设施目前普遍存在进料系统不稳定、玻璃结渣和高浓度HCl气体的排放的问题。这些技术难点已成为医疗废物焚烧处置行业发展的瓶颈。本文介绍了可解决上述问题的"可调节医疗废物恒流量进料技术"、"医废焚烧防玻璃结渣技术"和"含高浓度氯化氢医废尾气处理技术"三项医疗废物焚烧处理核心技术的主要特点及技术指标与应用实例。